Home > Order SKYLIFT Roof Risers > Aluminum & Louvered >

Apollo Saddle for Apollo Louvered Roof System-7-1/4" x 2-1/2"
apollo louvered roof riser bracket
18" roof riser bracket
  

Price with Selected Options

: $0.00


Availability: Usually Ships in 24 Hours
Product Code: APL-SKB


1.50" Pipe Flashing:

Length*:

Lateral High Wind Strap:

Qty:  
Description Technical Specifications Additional Item You'll Need
 

Custom Saddle for the Apollo Louvered Roof System

Use with 1.50" LIFETIME ULTIMATE FLASHING

About our 18” Roof Riser Products

The designer roof riser package includes the following components:

  • 18" or 24" Standard Duty Riser Base.
  • Structural screw
  • Structural nuts
  • Simpson SDS screws for riser base
  • Simpson SDS screws for top of the saddle
  • Heavy duty rubber washer
  • T40 Torx bit for SDS screws

Roof flashing add-on is not included in bracket purchase and should be purchased additionally for a fully-sealed riser installation.
Installation Overview
Professional Product Engineering stamp available. Rebate up to $60.
SkyLift Hardware - Engineering Express.
No rebate available for PROJECT engineering.


1. Determine approximate positioning or layout of all SkyLift roof riser brackets prior to cutting any access holes. SkyLift positioning must be directly over exterior bearing walls. Take into consideration roofing material layout, rafter locations, and interior conditions. Repositioning may be necessary due to discovered conditions.
2. Remove roofing shingles/tiles carefully and save for reinstall.
3. Square and mark location.
4. SET SAW DEPTH to avoid cutting concealed items. Check wall plate and avoid obstructions or concealed items.
5. Cut access hole (minimum 3-1/2" x 6") through the roof decking/sheating, directly over the exterior bearing wall.
6. If unfavorable conditions are discovered, reposition the bracket location. (Before cutting any roof trusses or rafters, always obtain expert guidance and professionally prepared plans.)
7. Insert the SkyLift roof riser bracket through the access hole and attach to the exterior wall top plate using 4 ea. 1/4" x 3" Simpson Strong-tie SDS screws (included).
DO NOT SUBSTITUTE FASTENERS.
8. Remove the SkyLift saddle and fit a standard pipe jack flashing (not included) over the SkyLift riser column. Follow manufacturer's instructions on sealing pipe jack flashing to roof.
9. Cut and fit the roofing (removed in step #3) around the pipe jack flashing and reinstall. 10. Replace the SkyLift saddle and bolt to the SkyLift riser column (3/8" bolt and nut included).
11. Seat your cross beam in the SkyLift saddle and secure with Simpson Strong-tie SDS screws (included)
DO NOT SUBSTITUTE FASTENERS.
See instructions included with bracket for important safety and warranty information, limitations of warranties and disclaimers.

Accessories
Ultimate Pipe Flashing 1.50" - For Standard Risers 1.5"-SkyLift Lateral Stabilizer Strap (LSS) Optional
Our Price: $67.99

Add
Our Price: $32.99

Add Free Shipping
Ultimate Pipe Flashing 1.50" - For Standard Risers 1.5"-SkyLift Lateral Stabilizer Strap (LSS) Optional